Technical Specifications
Electrical technical data
Power supply
12 ÷30 Vdc (polarity protected)
Accuracy (*)
(*) @25°C
refer to the specific graphs
Power consumption
0,25 W (without display)
0,5 W (with display)
Communication protocol
Modbus RTU (max. baud rate 38.400)
Serial interface
RS-485 (not insulated)
Input/Output insulation
None
Indicator LED
1 green led for the power supply
1 red led for the serial communication Tx
1 red led for the serial communication Rx
Range configurations
modifiable using the special EVOSER SET configuration kit (a PC with Windows operating system is required)
Electronic board operating temperature
-40 ÷65 °C
EMC
According to EN 61326-1:2013
Sensing element operating temperature range
-50 ÷450 °C
Sensing element
Pt1000 Ω @ 0°C
Accuracy class in accordance to IEC751 (*)
(*) The accuracy class is valid only in the temperature range indicated by the norm
cl. A
Response time (*)
(*) test in water in accordance with IEC 751. Time taken to reach 63.2% of temperature step
less than 3.5 seconds for Ø 3 mm and less than 13 seconds for diameter Ø 6 mm
M.I.C. min. bending radius
3 times the outer diameter (except the sensing tip which length is ~30 mm)
Sheet material
AISI 316
Realizable sheat lenghts L= (subject to feasibility check)
50 mm ÷10 m
Sheath diameter d
Ø 3 mm
Ø 6 mm
Connector
2 male M12 x 5 connectors in accordance with IEC 61076-2-101 STANDARDS
Maximum connection distance
1200 meters, this distance depends on the power supply voltage and the type of cable used to connect the various devices
Maximum devices on network
maximum 32 (over is required to add a serial repeater)
Material body
Grey thermoplastic
International protection marking (*)
(*) According to IEC 60529
IP65/67
Main device design parameters
Temperature °C
Maximum and minimum temperature peak measured
Temperature offset for measurement correction
Serial communication and power-on watch-dog
Option
4 digit display
Wall mounting bracket
connection cable with M12 connector
